1
OMA17C_AU
Congratulations on your purchase of the BOB
®
Travel Bag. It is designed to contain and
protect your single seat BOB Sport Utility, Revolution
®
or Stroller Strides
®
stroller during
transport. The Travel Bag may be rolled and guided by the end handle or carried via shoulder
strap and/or side handle. The Travel Bag will need to be assembled prior to use.
Before attempting to assemble or use your new Travel Bag, read and understand these
instructions to ensure proper assembly and operation. If you are unclear on any point,
contact your dealer or BOB before use.
FAILURE TO FOLLOW THESE WARNINGS AND ASSEMBLY INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR DEATH.
.
This product is designed exclusively for use with BOB single Sport Utility,
Revolution or Stroller Strides
®
strollers. It is not intended for use with
any other strollers, accessories or products.
.
When not in use, keep out of reach of children.
.
Maximum Weight Capacity 13.6Kg Do not overload.
.
Never leave child unattended.
.
The Travel Bag is designed to reduce the possibility of damage to your stroller
during transportation but does not eliminate it completely.
.
We recommend inspecting your stroller and Travel Bag before and after each
transport journey to ensure functionality and safety.
ASSEMBLY INSTRUCTIONS
1. Remove bag from packaging. Place bag flat on ground or table with wheels down. Open
Travel Bag top cover zipper and locate components. Fig. A identifies the anatomy and
components of the Travel Bag.
2. Unfasten the Velcro of the five fabric flaps along inboard sides of travel bag. Temporarily
place top of each over side and out of the way as shown in Fig. A.
3. Locate wall support panel, (black plastic sheet) unroll and note orientation of notch at
each end.
4. Orient wall support panel with notches toward top cover (up) and feed each end into each
respective pocket along inside corners of Travel Bag as shown in Fig B. Push ends of wall
support panel fully into each pocket until notch is aligned with pocket seam.
5. Align and fasten Velcro of fabric flaps straight and secure around wall support panel. You
may find it helpful to bend the support panel top edge slightly inboard while the Velcro of
each fabric flap is secured.
6. Locate fork dropout protector and
confirm it is attached securely to end
of small red webbing as shown in Fig.
C. The fork dropout protector can
be replaced easily if lost or damaged
with most other common fork dropout
protector(s) used on strollers and
bicycles for shipping, available through
your bicycle or stroller dealer.
Use Instructions:
7. Prepare Travel Bag: Zip Travel Bag
zipper completely open and fold top
cover over, exposing pockets for Front
Wheel and front wheel quick release
(QR). Locate center strap and unfasten
side release buckle. Place center strap
ends outboard of Travel Bag as shown
in Fig. 1.
8. Prepare stroller to place in Travel Bag. Remove contents from stroller (occupant and all
contents of Low Boy cargo basket). Remove stroller rear wheels. Close rear wheel QR’s. (See
rear wheel section of your stroller’s owner’s manual).
NOTE: Remove Snack Tray or Infant Car Seat Adapter and Infant Car Seat from strollers
featuring the Accessory Adapter. (See strollers owners manuals to verify if stroller has
accessory adapter).
9. Remove front wheel from stroller (See front wheel section of your stroller’s owner’s manual).
TRAVEL BAG INSTRUCTIONS
Fig. B: Panel ends into corner pocket
(right side shown).
Pocket Seam
Notch
Inside Notch fully
up toSeam
ENGLISH
Fig. C: Fork dropout protector shown
properly attached.
Red - Fork Protector
& Strap
Fig. 1: Travel Bag fully assembled and
prepared for stroller.
Center Strap open
with ends outboard
Top Cover Open
Fig. 2: Front QR anatomy shown
properly assembled.
Cam Housing
Rod
Conical
Springs
Adjusting Nut
Fig. A: Anatomy of the BOB Travel Bag
Zippered Top Cover
Wall Support Panel (rolled up)
Center Strap
& Buckle
Fork Protector
& Strap
Front QR
Pocket
Fabric Flaps
(open)
Shoulder Strap
Handles
Front Wheel
Pocket
QR Lever
BOB Gear
®
by Britax (03) 9288-7288
99 Derby Road, Sunshine, Victoria 3020
www.britax.com.au
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales